Product Installation
Quick, clean, and secure — no drilling required.
Whether you’re a glazing professional or a hands-on homeowner, fitting Bloom Blinds is fast and straightforward.
Just follow the three steps below for a perfect fit on your aluminium or uPVC bifolding doors, French doors, sliding doors, or windows.
Step 1: Measure the Glass Area
Accurate measurements ensure a seamless fit.
​
-
Measure only the visible glass – that’s the space between the black rubber seals (known as the gasket) inside the frame.
-
Measure the width at three points: top, middle, and bottom.
-
Use the smallest measurement for the width of your blind.
-
Record the glass height from top gasket to bottom gasket.
​
Tip: Your measurements can be taken by your window installer or done yourself — no tools beyond a tape measure needed.
Step 2: Insert the Anchor Points
Each Bloom Blind includes four anchors: two for the top, two for the bottom.
​
-
Unpack your blinds and check the contents.
-
Take the anchor clips and slide the thin edge between the glass and the gasket.
-
Position two anchors evenly at the top corners, and two at the bottom corners of the glass area.
​
Note: The anchors are designed to grip securely without damaging the glass or gasket.
Step 3: Fit the Blind
Secure and smooth — no drilling or adhesives needed.
-
Unwrap your blind and carefully remove the tape from the cords.
-
Start at the top:
-
Line the top bar of the blind with the upper anchors.
-
Press gently until you hear a “pop” — this means it’s locked in place.
-
-
Take the cords and feed them through the gateway slots in the bottom anchors.
-
Align the bottom bar with the lower anchors and push to click into place.
